Auto glass repair job can be really frustrating and it’s usually very expensive. So, the next time you experience a damaged auto glass, make sure that you can be able to repair it on your own, without having to spend a lot of money in costly repair fees. Fortunately, there are also some car repair shop like St. Louis auto glass repair that offers affordable and high-quality auto glass repair so make sure that you are able to find one if you think you can’t totally do the job yourself. But, if you think you are capable enough of doing the auto glass repair or replacement, then follow the steps below.  

  1. Survey the Damage

Prior to starting the auto glass repair job, it’s extremely important that you determine the damage’s extent first. Cracks, chips, and even some spider cracks can be repaired easily. On the other hand, cracks that have already developed their long veins are almost impossible to repair and might require general or full replacement of the glass that have been damaged. Thus, determining the crack’s severity is very simple and it shouldn’t need the pricey services of other auto glass repair service provider.  

  1. Clean the Damaged Area Thoroughly

Before you attempt to repair the crack, you should make sure first that the area with damage is spotless. This is because any dirt or debris that has been caked on is certainly liable to lead to bigger problems later on during the process of auto glass repair. In addition to that, if any debris or dirt remains right after the auto glass crack has been repaired, chances are it can usually be fished out using a safety pin so you have to make sure that you always remember this. 

  1. Attach the Stabilizer

Next to giving the glass crack a deep cleaning that it needs, you can then use adhesives in order to position carefully the suction cup-like stabilizer right on the damaged area. When doing this, you need to make sure that the stabilizer is being positioned carefully in place and you should also ensure that it’s firm. The moment the stabilizer comes off prior to the time it is supposed to, then you will most likely have to do the auto glass repair process one more time.  

  1. Attach the Applicator

If you have already placed the stabilizer in place, you will need to have the applicator attached to it and then you can start applying the resin to the glass’s damaged area. And, once the resin has already dried, you will be ready for the next procedure. 

  1. Apply the Film for Curing

Once you are sure that the resin is completely dry, remove both the applicator and the stabilizer gently and place a bit more resin on the area that has been repaired. After that, position the film for curing over it. But when doing this, you need to make sure that you take care during the process in order to avoid bubble formation. Remove the curing film once dried.